About me

I'm an engineer and love vaporizers.
When the quarantine hit, I started a little project and modified my Dynavap M. Cause of the isolation, I only used simple tools that most people have at home. The parts u need to build are cheap compared to the original parts.

I will post all my DIY projects here, so stay tuned!

If u want to support my projects, u can send me a donation for weed, beer and science

PEACE!

Kommentare

Kommentar veröffentlichen

Beliebte Posts aus diesem Blog

Heating sleeve

Bild
I just wrapped a titan sheet 0,5mm x 7mm around the lower part of a vapcap to expand the mass. When ur doing it the whole sheet metal should touch the cap. When u heat it, just use your torch on the sheet metal part.  First click should be enough, cause the heat needs more time to travel (just try). More mass means longer heating time, but also FAT hits! Too much for me but maybe u will like it. PEACE
Mehr anzeigen

Captive cap

Bild
Dynavap just created the captive cap. I dont see why you put the notch where the cap has no real elasticity. So i put the notch where it belongs, at the most flexible part of the cap. This is made with an '2019 M' Model, but it should also work with other tips. Not sure about the '2020 M tip' but it should work according to the pictures. Maybe someone can try and tell me if it works. Its pretty easy to do. you need: -Screw driver -Hammer Before you start smashing!  The cap must be pushed down all the way, or your notch wont be at the right place. Just take the screw driver as shown in the picture, point it behind the fin of the tip and give it a little hit with the hammer. Test it and use the hammer again if the hold is not stong enough. PEACE
Mehr anzeigen

The Italian

Bild
I sandet down a fusilli noodle and sticked it into an glass tube...super smooth not so tasty! Other materials work too. if your noodle moves take two o-rings. It should be away from the tip! I dont think more instructions are needet :) PEACE
Mehr anzeigen